Pricking bar / Punching cradle "Pro" with 120° angle
to prick paper layers prior to manual sewing
€104.00*
In stock, deliverable at short notice
The paper layers are placed centrally between the two rails and the holes are pricked evenly with an awl. Due to the pre-set hole spacing, the holes always have the identical distance to each other and to the top and bottom edge of the sheet.
NB: This item comes disassembled (this allows reducing shipping costs). The parts have to be glued before use. Cyanoacrylate glue (superglue) is recommended for this purpose.
- Version : 3D printed
- Colour : dark green
- Length (in mm) : 600
- Hole spacing (in mm) : 5
Application: for easy and even pricking of paper layers before manual sewing.
Advantages compared to the standard version (Items 59000000 / 59000001):
- 120º angle which is handy for larger layers, as the sides curve less, have more support by partially laying on the table. All this minimizes the risk of damaging the paper while punching holes in the fold. - The groove width in the bars is reduced from 3 mm to 1 mm, preventing layers from being pushed into the groove.
- At the head of the bar, there’s a screw now, that allows you to fine-tune the distance from the top of the layer to the first hole
- Corresponding part of the awl guide now has a magnet embedded, that keeps the guide secured in its position and not allowing it to shift. This ensures precise positioning of the holes in all layers.
- Fixtures that allow you to clamp the bar to your workbench and hang it on the wall when the work is done.
Properties of "Pricking bar / Punching cradle "Pro" with 120° angle"
| Dimensions | |
| Hole spacing (in mm): | 5 |
|---|---|
| Length (in mm): | 600 |
| Colour | |
| Colour: | dark green |
| Other properties | |
| Category: | Sewing Books, Sewing frames and accessories, iBookBinding Tools |
| Version: | 3D printed |
Login
Recommendations
In stock, deliverable at short notice
Accessories
In stock, deliverable at short notice
